Nissan Altima Owners Manual: Fog lights (if so equipped)
1. Disconnect the negative battery cable.
2. Remove the fasteners A ; carefully pull back the front fender protector .
3. Rotate the bulb B counterclockwise and pull out to remove.
Reverse steps to install.
Headlights
Replacing the xenon headlight bulb (if
so equipped)
WARNING
HIGH VOLTAGE
When xenon headlights are on, they produce
a high voltage. To prevent an electric
shock, never attempt to modify or disas ...
Park/turn signal lights
1. Disconnect the negative battery cable.
2. Remove the fasteners A ; carefully pull back
the front fender protector.
3. Rotate the bulb B counterclockwise and
pull out to remove. ...
Other materials:
P0730 belt damage
Description
TCM selects the gear ratio using the engine load (throttle position), the
primary pulley revolution speed, and
the secondary pulley revolution speed as input signal. Then it changes the
operating pressure of the primary
pulley and the secondary pulley and changes the groove width ...
BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspec ...
Bose speaker AMP
Removal and Installation - Coupe
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal
and Installation".
3. Remove the RH trunk floor spacer.
4. Remove the Bose speaker amp. screws (A), then disc ...