Nissan Altima 2007-2012 Service Manual: Front bumper
Removal and Installation
1. Front bumper supports
2. Front bumper side bracket
3. Reinforcement bracket
4. Front bumper reinforcement
5. Front energy absorbing foam
6. Front bumper fascia
7. Tow hook cover
8. Front grille
9. License plate bracket
10. Fog lamp finisher (if equipped)
11. Fog lamp (if equipped)
A. Clip C101
REMOVAL
1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation".
2. Remove the engine under cover.
3. Remove the RH and LH side under covers.
4. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".
5. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.
6. Remove the front grille. Refer to EXT-17, "Removal and Installation".
7. Remove the front energy absorbing foam.
8. Remove the front bumper reinforcement and reinforcement bracket.
9. Remove the front bumper supports.
INSTALLATION
Installation is in the reverse order of removal.
Rear bumper
Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. R ...Other materials:
Inspection and adjustment
ECM RE-COMMUNICATING FUNCTION
Description
Performing following procedure can automatically perform re-communication of
ECM and BCM, but only when
the ECM has been replaced with a new one (*1).
*1: New one means an ECM which has never been energized on-board.
(In this step, initialization ...
Power window lock switch
Description
Ground circuit of main power window and door lock/unlock switch shuts off if
power window lock switch of
main power window and door lock/unlock switch is operated. This inhibits all
operation, except for the main
switch.
Component Function Check
1. CHECK POWER WINDOW LOCK SIGNA ...
Bose speaker AMP
Removal and Installation - Coupe
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal
and Installation".
3. Remove the RH trunk floor spacer.
4. Remove the Bose speaker amp. screws (A), then disc ...