Nissan Altima 2007-2012 Service Manual: Front door speaker
Removal and Installation
REMOVAL
1. Remove the front door finisher. Refer to INT-12, "Removal and Installation" (coupe) and INT-34, "Removal and Installation" (sedan).
2. Remove the front door speaker screws (A), then disconnect the front door speaker connector and remove the front door speaker (1).
INSTALLATION
Installation is in the reverse order of removal.
Center speaker
Removal and Installation REMOVAL 1. Remove the center speaker grille. Refer to IP-12, "Removal and Installation". 2. Remove the center speaker screws (A), then pull out the center s ...Rear door speaker
Removal and Installation - Sedan REMOVAL 1. Remove the rear door finisher. Refer to INT-34, "Removal and Installation". 2. Remove the rear door speaker screws (A), then disconnect th ...Other materials:
B260C steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF.
3. Press door switch ...
B2606 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2606 is displayed with DTC U1000, first per ...
Electric ignition system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*1: This signal is sent to the ECM through CAN communication line.
*2: ECM determines the start signal status by the signals of engine speed and
battery voltage.
SYSTEM DESCRIPTION
Firing order: 1 - 3 - 4 - 2
The ignition t ...