Nissan Altima 2007-2012 Service Manual: Front door speaker (sedan)

Description

The audio unit sends audio signals to the front door speakers using the door speaker circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect audio unit connector M43 (A) and suspect speaker connector (B).

2. Check continuity between audio unit harness connector M43 (A) terminal and suspect speaker harness connector (B) terminal.

3. Check continuity between audio unit harness connector M43 (A) terminal and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.FRONT DOOR SPEAKER SIGNAL CHECK

1. Connect audio unit connector and front speaker connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between audio unit harness connector terminals with CONSULT-III or oscilloscope.

Is the audio signal voltage as specified? YES >> Replace speaker. Refer to AV-74, "Removal and Installation".

NO >> Replace audio unit. Refer to AV-72, "Removal and Installation".

    Door speaker (coupe)
    Description The audio unit sends audio signals to the door speakers using the door speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect s ...

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the front tweeters using the door speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect ...

    Other materials:

    P0506 ISC System
    Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

    P0447 Evap canister vent control valve
    Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the ca ...

    Precaution
    Precautions for Trouble Diagnosis CAUTION: • Never apply 7.0 V or more to the measurement terminal. • Use a tester with open terminal voltage of 7.0 V or less. • Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness. Prec ...