Nissan Altima 2007-2012 Service Manual: Front fog lamp

Aiming Adjustment

The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment, make sure of the following.

• Keep all tires inflated to correct pressure.

• Place vehicle on level ground.

• See that vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). Have the driver or equivalent weight placed in driver seat.

• Adjust aiming in the vertical direction by turning the adjusting screw (A).

• When performing adjustment, if necessary, cover the headlamps and opposite fog lamp.

1. Set the distance between the screen and the center of the fog lamp lens as shown.

2. Turn front fog lamps ON.

3. Adjust front fog lamps using adjusting screw so that the top edge of the high intensity zone is 100 mm (4 in) below the height of the fog lamp centers as shown.

    Headlamp
    Aiming Adjustment PREPARATION BEFORE ADJUSTING NOTE: • For details, refer to the regulations in your area. • Perform aiming adjustment if the vehicle front body has been repaired and/or t ...

    On-vehicle repair
    ...

    Other materials:

    CVT fluid
     RE0F09B Inspection CHECKING CVT FLUID Fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to 176°F). The fluid level check procedure is as follows: 1. Check for fluid leakage. 2. With the engine warmed up, drive the vehicle in an urban area. When ambient t ...

    P1777 step motor
    Description The step motor changes the step with turning 4 coils ON/OFF according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive v ...

    B2557 vehicle speed
    Description BCM receives the 2 vehicle speed signals via CAN communication. 1 signal is transmitted by the “unified meter” Another signal is transmitted by “ABS actuator and electric unit (control unit)”. BCM compares both signals to detect the vehicle speed. DTC Logic DTC DETECTIO ...