Nissan Altima 2007-2012 Service Manual: Front regulator
Exploded View
1. Door
2. Inside seal
3. Door glass
4. Regulator assembly
5. Door module assembly
6. Window motor
Disassembly
Remove the window motor nuts (A) the four window regulator bolts (B) and the window motor (1) from the door module assembly. On the back side remove the window regulator from the door module assembly.
Assembly
Assembly is in the reverse order of disassembly.
Rear regulator
Exploded View 1. Rear door 2. Door glass run 3. Door glass 4. Inside seal 5. Partition sash 6. Door rear glass seal 7. Door rear glass 8. Regulator assembly 9. Window motor 10. Water shiel ...Other materials:
Intermittents incident
Inspection Procedure
INTERMITTENT TROUBLE
An intermittent incident may have occured in the past but is not being
detected currently. This DTC will not be
detected on SELF DIAG [CURRENT], but may be viewed on SELF DIAG [PAST] using
CONSULT-III.
Trouble Diagnosis with CONSULT-III
DIAGNOSTIC P ...
During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
● “Send” – Speak this command followed by
the digits to enter digits during the phone
call.
● “Mute On” or “Mute Off” – Speak the command
to mute or unmu ...
B2617 starter relay circuit
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2617 is display ...