Nissan Altima (L32) 2007-2012 Service Manual: Front washer nozzle
Removal and Installation
REMOVAL
1. Remove the cowl top cover For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" 2. Push washer nozzle tab (A), to release the washer nozzle (1) from the cowl top cover, then disconnect the washer nozzle hose (2).
INSTALLATION
1. Installation is in the reverse order of removal.
2. Adjust nozzle spray location. Refer to WW-119, "FRONT WASHER NOZZLE : Adjustment".
Adjustment
Adjust spray positions to match the positions as shown.
*1: Spray positions are aiming targets, heights are allowable spray patterns above the target points.
Insert a suitable tool (A) into the nozzle hole (B) and move up/down and left/right to adjust the spray position of the nozzle (1).
Washer tube
Layout 1. Washer nozzle LH 2. Washer nozzle hose LH 3. Washer nozzle RH 4. Washer nozzle hose RH 5. Y-tube connector 6. Clip 7. Washer tank hose 8. Washer tank A. Tube connectors ...Washer tank
Removal and Installation REMOVAL 1. Remove the washer tank filler tube (1). 2. Remove engine under cover. 3. Position the RH fender protector back. For Sedan Refer to EXT-40, "Removal a ...Other materials:
P0603 ECM Power supply
Description
Battery voltage is supplied to the ECM even when the ignition switch
is turned OFF for the ECM memory function of the DTC memory, the
air-fuel ratio feedback compensation value memory, the idle air volume
learning value memory, etc.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATI ...
Hood
1 Pull the hood lock release handle located
below the driver’s side instrument panel; the
hood springs up slightly.
2 Push the lever at the front of the hood to the
side as illustrated with your fingertips and
raise the hood.
3 Remove the support rod from the clamp.
4 Insert the support r ...
TCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (unit side and connector
side).
- TCM
- Harne ...