Nissan Altima 2007-2012 Service Manual: Front wiper auto stop signal circuit

Component Function Check

1. CHECK FRONT WIPER (AUTO STOP) OPERATION

1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item.

2. Operate the front wiper.

3. With the front wiper operation, check the monitor status.

Is the status of item normal? YES >> Auto stop signal circuit is normal.

NO >> Refer to WW-24, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK FRONT WIPER MOTOR (AUTO STOP) OUTPUT VOLTAGE

1. Turn the ignition switch OFF.

2. Disconnect front wiper motor.

3. Turn the ignition switch ON.

4. Check voltage between IPDM E/R harness connector and ground.

Is the measurement normal? YES >> GO TO 2

NO >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

2. CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT CONTINUITY

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R.

3. Check continuity between IPDM E/R harness connector (A) and front wiper motor harness connector (B).

Does continuity exist? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK FRONT WIPER MOTOR (AUTO STOP) SHORT CIRCUIT

Check continuity between IPDM E/R harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> Replace front wiper motor. Refer to WW-116, "FRONT WIPER DRIVE ASSEMBLY : Removal and Installation".

    Front wiper motor hi circuit
    Component Function Check 1. CHECK FRONT WIPER HI OPERATION 1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description". 2. Check that the front wiper operates at the ...

    Front wiper motor ground circuit
    Diagnosis Procedure 1.CHECK FRONT WIPER MOTOR (GND) OPEN CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect front wiper motor. 3. Check continuity between front wiper motor harness connec ...

    Other materials:

    P0037, P0038 HO2S2 heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF control of the heated oxygen sensor 2 heater corresponding to the engine speed, amount of intake air and engine coolant temperature. OPERATION DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Con ...

    Rear speaker
    Description The audio unit sends audio signals to the rear speakers using the rear speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect speaker connector. 2. Check continuity between audio unit harness connector M43 (A) and suspect ...

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the front tweeters using the door speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect tweeter connector (B). 2. Check continuity between audio unit harness connector M43 (A) and su ...