Nissan Altima 2007-2012 Service Manual: Front wiper drive assembly

Removal and Installation

REMOVAL

1. Operate front wiper motor, and stop at the auto stop position.

2. Remove wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

3. Remove the cowl top cover. For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation".

4. Remove the strut brace bolts (A), detach the wiper drive assembly harness clips, then remove the strut brace (1).

5. Detach the wiper drive harness clip from the wiper drive assembly frame.

6. Remove the front wiper drive assembly bolts (A), disconnect the wiper drive motor connector (B) and remove the front wiper drive assembly (1).

INSTALLATION

1. Install the front wiper drive assembly.

2. Connect wiper motor connector. Turn wiper switch ON to operate wiper motor, then turn wiper switch OFF (auto stop).

3. Attach the wiper drive harness clip to the wiper drive assembly frame.

4. Install the strut brace, then attach the wiper drive assembly harness clips.

5. Install the cowl top cover. For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" 6. Attach the wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

7. Adjustment of wiper arm stop location. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

    Front wiper ARMS
    Removal and Installation REMOVAL 1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch OFF (auto stop). 2. Open hood, remove arm caps, and remove wiper arm nuts. 3. Rais ...

    Other materials:

    Audio unit
     Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. 2.POWER SUPPLY CIRCUIT CHECK 1. Disconnect audio unit connector ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B122 and suspe ...