Nissan Altima (L32) 2007-2012 Service Manual: Front wiper motor ground circuit
Diagnosis Procedure
1.CHECK FRONT WIPER MOTOR (GND) OPEN CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector and ground.
Does continuity exist? YES >> Front wiper motor ground circuit is normal.
NO >> Repair or replace harness.
Front wiper auto stop signal circuit
Component Function Check
1. CHECK FRONT WIPER (AUTO STOP) OPERATION
1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item.
2. Operate the front wiper.
3. With the front wiper ...
Front wiper and washer system
Wiring Diagram-Coupe
Wiring Diagram-Sedan
...
Other materials:
P0615 start signal
Description
• TCM controls starter relay in IPDM E/R.
• TCM switches starter relay ON at “P” or “N” position and allows to crank
engine.
• Then it prohibits cranking other than at “P” or “N” position.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUT ...
Side guard molding
Removal and Installation
1. Double-faced adhesive tape
Removal
CAUTION:
Never apply tack-paper adhesive remover to body panel surface finished with
lacquer-based paints.
• Original side guard molding is affixed to body panel with double-faced
adhesive tape.
1. Heat molding to betwe ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
