Nissan Altima (L32) 2007-2012 Service Manual: Function diagnosis
- Intelligent key system/engine start function
- NVIS (Nissan vehicle immobilizer system-nats)
- Vehicle security system
- Diagnosis system (BCM)
Inspection and adjustment
ECM RE-COMMUNICATING FUNCTION
Description
Performing following procedure can automatically perform re-communication of
ECM and BCM, but only when
the ECM has been replaced with a new one (*1).
...
Intelligent key system/engine
start function
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The engine start function of Intelligent Key system is a system that makes
it possible to start and stop ...
Other materials:
P0643 Sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
...
Blower motor
Description
SYSTEM DESCRIPTION
Component Parts
Fan speed control system components are:
• Front air control
• A/C LAN system (PBR built-in mode door motor, air mix door motor and intake
door motor)
System Operation
Component Function Check
INSPECTION FLOW
1. CONFIRM SYMPTOM BY PERF ...
Supplemental air bag warning labels
Warning labels about the supplemental
front-impact air bag system are placed in
the vehicle as shown in the illustration.
WARNING
Do not use a rear-facing child restraint
on a seat protected by an air bag in
front of it. If the air bag deploys, it may
cause serious injury or death.
Supplemental air ...
