Nissan Altima manuals

Nissan Altima (L32) 2007-2012 Service Manual: Hands free phone system (sedan)

System Diagram

System Description

Refer to the owner's manual for Bluetooth telephone system operating instructions.

NOTE: Cellular telephones must have their wireless connection set up (paired) before using the Bluetooth telephone system.

Bluetooth telephone system allows users who have a Bluetooth cellular telephone to make a wireless connection between their cellular telephone and the AV control unit. Hands-free cellular telephone calls can be sent and received. Personal memos can be created using the Nissan Voice Recognition system. Some Bluetooth cellular telephones may not be recognized by the AV control unit. When a cellular telephone or the AV control unit is replaced, the telephone must be paired with the AV control unit. Different cellular telephones may have different pairing procedures. Refer to the cellular telephone operating manual.

AV CONTROL UNIT

When the ignition switch is turned to ACC or ON, the AV control unit will power up. During power up, the AV control unit is initialized and performs various self checks. Initialization may take up to 10 seconds. During this time the Bluetooth ON indicator will flash until initialization is complete. If a phone is present in the vehicle and paired with the AV control unit, Nissan Voice Recognition will then become active and the Bluetooth ON indicator will remain on. Bluetooth telephone functions can be turned off using the Nissan Voice Recognition system.

STEERING WHEEL AUDIO CONTROL SWITCHES

When buttons on the steering wheel audio control switch are pushed, the resistance in steering wheel audio control switch circuit changes depending on which button is pushed. The AV control unit uses this signal to perform various functions while navigating through the voice recognition system.

The following functions can be performed using the steering wheel audio control switch: • Initiate Self-Diagnosis of the Bluetooth telephone system

• Start a voice recognition session

• Answer and end telephone calls

• Adjust the volume of calls

• Record memos

MICROPHONE

The microphone is located in the roof console assembly. The microphone sends a signal to the AV control unit.

The microphone can be actively tested during self-diagnosis.

Component Parts Location

1. Tweeter LH M51

2. Steering wheel audio control switches

3. CD changer M42

4. Tweeter RH M52

5. AV control unit M46, M47, M48, M81, M90, M91

6. Center speaker M151

7. Combination meter M24

8. Front door speaker

LH D3

RH D103

9. Rear subwoofer RH B124

10. Rear subwoofer LH B120

11. Rear door speaker

LH D202

RH D302

12. Antenna amp M502 (view with rear pillar finisher RH removed)

13. BOSE speaker amp. B121, B122

14. Microphone R7

15. Rear view camera control unit B31 (view with trunk side finisher LH removed)

16. Rear view camera B35

Component Description

Hands free phone system (coupe)
System Diagram System Description Refer to the owner's manual for Bluetooth telephone system operating instructions. NOTE: Cellular telephones must have their wireless connection set up (pa ...

Diagnosis system (AV control unit)
Diagnosis Description DESCRIPTION • Diagnosis function consists of the self-diagnosis mode performed automatically and the CONFIRMATION/ ADJUSTMENT mode operated manually. • Self-diagnosi ...

Other materials:

Power steering fluid
Inspection FLUID LEVEL • Check fluid level with engine stopped. • Make sure that fluid level is between MIN and MAX. • Fluid levels at HOT (A) and COLD (B) are different. Do not confuse them. CAUTION: • The fluid level should not exceed the MAX line. Excessive fluid will caus ...

Break-in schedule
CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance. & ...

Function information
Component Part Location ENGINE COMPARTMENT 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) PASSENGER ...