Nissan Altima 2007-2012 Service Manual: Hazard switch
Removal and Installation
Removal
1. Remove the cluster lid C. Refer to IP-12, "Removal and Installation".
2. Remove CVT finisher or M/T finisher. Refer to TM-255, "Removal and Installation" or TM-21, "Removal and Installation".
3. Remove the hazard switch screws (A) and remove the hazard switch. (1).
Installation
Installation is in the reverse order of removal.
Lighting and turn signal switch
Removal and Installation
Removal
1. Remove the spiral cable. Refer to SR-8, "Removal and Installation"
2. Disconnect the lighting and turn signal switch connector and remove the
lighti ...
Service data and specifications
(SDS)
Headlamp
*: Always check with the Parts Department for the latest parts information.
Exterior Lamp
*: Always check with the Parts Department for the latest parts information. ...
Other materials:
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold
temperature starting.
The engine block heater should be used when
the outside temperature is 20°F (-7°C) or lower.
WARNING
● Do not use your engine block heater
with an ungrounded electrical system or
a 2-pronged adapter. You can be ...
P0300, P0301, P0302, P0303, P0304 misfire
DTC Logic
DTC DETECTION LOGIC
When a misfire occurs, engine speed will fluctuate. If the engine speed
fluctuates enough to cause the crankshaft
position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is
occurring.
The misfire detection logic consists of the following ...
BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. ...
