Nissan Altima (L32) 2007-2012 Service Manual: Hazard warning lamps flash
Hazard Warning Lamps Flash When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM GROUND CIRCUIT
Check BCM ground circuit. Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Repair BCM ground circuit.
Low tire pressure warning lamp blinks
Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On NOTE: If low tire pressure warning lamp flashes as shown, the system is normal. Flash Mode A • This mode shows transmitt ...ID Registration cannot be completed
ID Registration Cannot Be Completed DIAGNOSTIC PROCEDURE 1.PERFORM ID REGISTRATION OF ALL TRANSMITTERS Carry out ID registration of all transmitters. Refer to WT-6, "ID Registration Procedu ...Other materials:
P0451 Evap control system pressure sensor
Description
The EVAP control system pressure sensor detects pressure in the
purge line. The sensor output voltage to the ECM increases as pressure
increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously condu ...
Disassembly and assembly
FRONT SEAT
DRIVER SIDE
Exploded View
1. Headrest
2. Headrest holder (locked)
3. Headrest holder (free)
4. Seatback board
5. Seatback/frame assembly
6. Inner finisher
7. Seat belt buckle
8. Seat cushion trim
9. Seat harness
10. Seat cushion pad
11. Front leg covers
12. Lumbar l ...
Key cylinder switch
Description
For vehicles equipped with LH and RH anti-pinch system, the main power window
and door lock/unlock switch
detects condition of the door key cylinder switch and transmits to BCM as the
LOCK or UNLOCK signal.
For vehicles equipped with LH anti-pinch system only, the front door loc ...