Nissan Altima (L33) 2013-2018 Owners Manual: Headlights
Replacing the xenon headlight bulb (if so equipped)
WARNING
HIGH VOLTAGE
When xenon headlights are on, they produce a high voltage. To prevent an electric shock, never attempt to modify or disassemble.
Always have your xenon headlights replaced at a NISSAN dealer. For additional information, see “Headlight and turn signal switch” in the “Instruments and controls” section.
Replacing the halogen headlight bulb (if so equipped)
If bulb replacement is required, see your NISSAN dealer.
CAUTION
● Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.
● Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.
● Only touch the base when handling the bulb. Never touch the glass envelope.
Touching the glass could significantly affect bulb life and/or headlight performance.
● High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.
● Use the same number and wattage as shown in the chart.
Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.
Lights
...
Fog lights (if so equipped)
1. Disconnect the negative battery cable.
2. Remove the fasteners A ; carefully pull back
the front fender protector .
3. Rotate the bulb B counterclockwise and
pull out to remove.
Reverse st ...
Other materials:
Door finisher
Exploded View
1. Mirror cover
2. Front door finisher
3. Step lamp lens
4. Rear door finisher
5. Step lamp/reflector lens (if equipped)
6. Arm rest finisher
7. Rear door power window switch finisher
8. Inside release handle
9. Inside release handle escutcheon
9. Inside release handle esc ...
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...
Audio unit (sedan)
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram — Sedan
...
