Nissan Altima 2007-2012 Service Manual: Heater core

Removal and Installation

COMPONENTS

1. Heater grommet

2. Heater pipe support

3. Heater and cooling unit foot duct LH

4. Heater core

5. Heater and cooling unit case

REMOVAL

1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and Installation".

2. Remove the heater grommet, heater pipe support and heater pipe cover.

3. Remove the heater and cooling unit foot duct LH.

4. Remove the heater core.

INSTALLATION

Installation is in the reverse order of removal.

• Make sure that the aspirator hose is securely attached to the aspirator on the heater and cooling unit foot duct LH.

    Evaporator
    Removal and Installation COMPONENTS 1. Heater and cooling unit case 2. Evaporator 3. Intake sensor 4. In-cabin microfilter 5. Evaporator cover 6. Heater and cooling unit foot duct RH 7. Blow ...

    Ducts and grilles
    ...

    Other materials:

    P0443 Evap canister purge volume control solenoid valve
    Description The EVAP canister purge volume control solenoid valve is used to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount of fuel vapor th ...

    Idle speed
    Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IDLE SPEED Check idle speed in “DATA MONITOR” mode with CONSULT-III. Check idle speed with Service $01 of GST. > ...

    Charging system preliminary inspection
    Inspection Procedure 1.CHECK BATTERY TERMINALS CONNECTION Check if battery terminals are clean and tight. Is the inspection result normal? YES >> GO TO 2 NO >> Repair battery terminals connection. 2.CHECK FUSE Check for blown fuse and fusible link. Is the inspection result n ...