Nissan Altima 2007-2012 Service Manual: High-pressure flexible hose

Removal and Installation for High-Pressure Flexible Hose

QR25DE

Removal

1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure".

2. Reposition the power steering reservoir out of the way without disconnecting the hose.

3. Reposition the engine coolant reservoir out of the way without disconnecting the hose.

4. Remove the high-pressure flexible hose. Refer to HA-31, "Component".

CAUTION: Cap or wrap the joint of the hose with a suitable material such as vinyl tape to avoid the entry of contaminants.

Installation

Installation is in the reverse order of removal.

CAUTION: • Replace the O-ring of the high-pressure flexible hose with a new one, then apply A/C oil to it for installation.

• After charging the refrigerant, check for leaks. Refer to HA-25, "Checking of Refrigerant Leaks".

VQ35DE

Removal

1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure".

2. Remove the engine cooling fan and shroud assembly. Refer to CO-40, "Removal and Installation".

3. Reposition the power steering reservoir out of the way without disconnecting the hose.

4. Reposition the engine coolant reservoir out of the way without disconnecting the hose.

5. Remove the high-pressure flexible hose. Refer to HA-31, "Component".

CAUTION: Cap or wrap the joint of the hose with a suitable material such as vinyl tape to avoid the entry of contaminants.

Installation

Installation is in the reverse order of removal.

CAUTION: • Replace the O-ring of the high-pressure flexible hose with a new one, then apply A/C oil to it for installation.

• After charging the refrigerant, check for leaks. Refer to HA-25, "Checking of Refrigerant Leaks".

    Low-pressure pipe
    Removal and Installation for Low-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Ref ...

    High-pressure pipe
    Removal and Installation for High-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Re ...

    Other materials:

    B2553 ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse block) • Blower fan motor relay BCM checks any ignition relay ON request for consistency wit ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...