Nissan Altima 2007-2012 Service Manual: Horn

Description

Horn (high/low) is located inside of front bumper and operates when theft warning system is in alarm phase.

Component Function Check

1.CHECK FUNCTION

1. Select HORN in “ACTIVE TEST” mode with CONSULT-III.

2. Check the horn (high/low) operation.

Is the operation normal? YES >> Inspection End.

NO >> Refer to SEC-120, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HORN FUNCTION

Check horn function with horn switch Do the horns sound? YES >> GO TO 2

NO >> Refer to HRN-3, "Wiring Diagram - Coupe".

2.CHECK HORN RELAY POWER SUPPLY

1. Turn ignition switch ON.

2. Perform “ACTIVE TEST” (“HORN”) with CONSULT-Ill.

3. Using an analog voltmeter or an oscilloscope, check voltage between IPDM E/R connector E17 terminal 44 and ground.

Is the inspection result normal? YES >> Repair or replace harness between IPDM E/R and horn relay.

NO >> GO TO 3.

3.CHECK HORN RELAY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R and horn relay connector.

3. Check continuity between IPDM E/R harness connector and horn relay harness connector.

4. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace harness.

4.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace IPDM E/R.Refer to PCS-48, "Removal and Installation".

NO >> Repair or replace the malfunctioning part.

    Key cylinder switch
    Description For vehicles equipped with LH and RH anti-pinch system, the main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the ...

    Headlamp
    Description Headlamp lighting when theft warning system is alarm phase. Component Function Check 1.CHECK HEADLAMP OPERATION Check if headlamp operate by lighting switch. Does headlamp come on ...

    Other materials:

    Auto light system
    Wiring Diagram - Coupe Wiring Diagram - Sedan ...

    B1150 – B1153 side curtain air bag module LH
    Description DTC B1150 – B1153 LH SIDE CURTAIN AIR BAG MODULE The LH side curtain air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the LH side curtain air bag module. PART LOCATION Refer t ...

    Power steering fluid
    Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 0 to 30ºC (32 to 86ºF). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...