Description

Horn (high/low) is located inside of front bumper and operates when theft warning system is in alarm phase.

Component Function Check

1.CHECK FUNCTION

1. Select HORN in “ACTIVE TEST” mode with CONSULT-III.

2. Check the horn (high/low) operation.

Is the operation normal? YES >> Inspection End.

NO >> Refer to SEC-510, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HORN FUNCTION

Check horn function with horn switch Do the horns sound? YES >> GO TO 2

NO >> Refer to HRN-7, "Wiring Diagram - Sedan".

2.CHECK HORN RELAY POWER SUPPLY

1. Turn ignition switch ON.

2. Perform “ACTIVE TEST” (“HORN”) with CONSULT-Ill.

3. Using an analog voltmeter or an oscilloscope, check voltage between IPDM E/R connector E17 terminal 44 and ground.

Is the inspection result normal? YES >> Repair or replace harness between IPDM E/R and horn relay.

NO >> GO TO 3

3.CHECK HORN RELAY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R and horn relay connector.

3. Check continuity between IPDM E/R harness connector and horn relay harness connector.

4. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace harness.

4.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace IPDM E/R.Refer to PCS-48, "Removal and Installation".

NO >> Repair or replace the malfunctioning part.