Nissan Altima 2007-2012 Service Manual: Hydraulic control system

System Diagram

System Description

The hydraulic control mechanism consists of the oil pump directly driven by the engine, the hydraulic control valve that controls line pressure and transmission, and the input signal line.

LINE PRESSURE AND SECONDARY PRESSURE CONTROL

• When an input torque signal equivalent to the engine drive force is sent from the ECM to the TCM, the TCM controls the line pressure solenoid valve and secondary pressure solenoid valve.

• This line pressure solenoid controls the pressure regulator valve as the signal pressure and adjusts the pressure of the operating oil discharged from the oil pump to the line pressure most appropriate to the driving state. Secondary pressure is controlled by decreasing line pressure.

Nomal Control

Optimize the line pressure and secondary pressure, depending on driving conditions, on the basis of the throttle position, the engine speed, the primary pulley (input) revolution speed, the secondary pulley (output) revolution speed, the brake signal, the PNP switch signal, the lock-up signal, the voltage, the target gear ratio, the fluid temperature, and the fluid pressure.

Feedback Control

When controlling the normal fluid pressure or the selected fluid pressure, the secondary pressure can be set more accurately by using the fluid pressure sensor to detect the secondary pressure and controlling the feedback.

Component Parts Location - Coupe

1. Control device assembly (Manual mode select switch and manual mode position select switch)

2. Accelerator pedal position (APP) sensor

3. Secondary speed sensor

4. CVT unit harness connector

5. TCM

6. Battery

7. Shift position indicator Manual mode indicator

Component Parts Location - Sedan

1. Control device assembly (Manual mode select switch and manual mode position select switch)

2. Accelerator pedal position (APP) sensor

3. Secondary speed sensor

4. CVT unit harness connector

5. TCM

6. Battery

7. Shift position indicator Manual mode indicator

Component Description

TRANSAXLE ASSEMBLY

EXCEPT TRANSAXLE ASSEMBLY

    Mechanical system
    Cross-Sectional View 1. Converter housing 2. Oil pump 3. Forward clutch 4. Reverse brake 5. Planetary carrier 6. Primary pulley 7. Steel belt 8. Sun gear 9. Side cover 10. Internal gear 1 ...

    Control system
    System Diagram System Description The CVT senses vehicle operating conditions through various sensors. It always controls the optimum shift position and reduces shifting and lock-up shocks. C ...

    Other materials:

    Does not operate by key cylinder switch
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...

    Radio
    With the ignition placed in the ACC or ON position, press the PWR (power)/VOL (volume) knob to turn the radio on. If you listen to the radio with the engine not running, the ignition should be placed in the ACC position. Radio reception is affected by station signal strength, distance from r ...

    U1000 can comm circuit
    DescriptionCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each ...