Nissan Altima 2007-2012 Service Manual: Ignition timing

Description

This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

IGNITION TIMING : Special Repair Requirement

1.CHECK IGNITION TIMING

1. Attach timing light to No. 1 igniton coil (1) wire as shown.

2. Check ignition timing.

1 : Timing indicator

>> INSPECTION END

    Idle speed
     Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. IDLE SPEED : Special Repair Requirement 1.CHECK IDLE S ...

    Vin registration
    Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspec ...

    Other materials:

    Front seat head restraints/headrests
    WARNING ● Head restraints/headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjust the head restraints/headrests properly, as specified in this section. Check the adjustment after someone else ...

    P0453 Evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously condu ...

    Stop lamp
    Bulb Replacement Removal 1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation". 2. Turn bulb socket counterclockwise to unlock and remove from combination lamp assembly. 3. Turn bulb counterclockwise to remove from bulb socket. Installation Installati ...