Nissan Altima 2007-2012 Service Manual: Ignition timing

Description

This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

Special Repair Requirement

1.CHECK IGNITION TIMING

1. Attach timing light to No. 1 igniton coil (1) wire as shown.

2 : Timing light

2. Check ignition timing.

1 : Timing indicator

>> INSPECTION END

    Idle speed
    Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IDLE SPEED Check idle s ...

    Vin registration
    Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspec ...

    Other materials:

    B1086 – B1089 seat belt pre-tensioner LH
    Description DTC B1086 – B1089 SEAT BELT PRE-TENSIONER LH The seat belt pre-tensioner LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the seat belt pre-tensioner LH. PART LOCATION Refer to SRC-7, &qu ...

    Low-pressure pipe
    Removal and Installation for Low-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Refer to FSU-12, "Exploded View". 3. Remove the upper cowl. Refer to EXT-18, "Removal ...

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...