Nissan Altima 2007-2012 Service Manual: Illumination

Removal and Installation

TRUNK ROOM LAMP

Removal

1. Disconnect the negative battery terminal.

2. Release the tab (A), then swing open the lens.

3. Remove the bulb (3).

4. Release the tab (B), then pull trunk room lamp (2) away from body opening.

5. Disconnect the connector (1) and remove trunk room lamp.

Installation

Installation is in the reverse order of removal.

Bulb Replacement

1. Disconnect the negative battery terminal.

2. Release the tab (A), then swing open the lens.

3. Pull bulb (3) straight out to remove.

    Interior room lamp
    Removal and Installation FRONT ROOM/MAP LAMP NOTE: For non-sunroof equipped vehicles, the front room/map lamp assembly is an integral part of the headinlining and repaired only as an assembly. R ...

    Service data and specifications (SDS)
    Bulb Specifications * Always check with the Parts Department for the latest parts information. ...

    Other materials:

    P1720 VSS
    Description ECM receives two vehicle speed signals via the CAN communication line. One is sent from “ABS actuator and electric unit (control unit)” via the combination meter, and the other is from TCM (Transmission control module). ECM uses these signals for engine control. DTC Logic ...

    Cup holders
    Front Rear The rear center cup holders are located in the rear fold-down armrest. CAUTION ● Avoid abrupt starting and braking when the cup holder is being used to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger. ● Use only soft cups in th ...

    ECU diagnosis
    IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram — Coupe Wiring Diagram — Sedan Fail Safe CAN COMMUNICATION CONTROL When CAN communication ...