Nissan Altima 2007-2012 Service Manual: In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and Installation".
2. Remove the in-vehicle sensor screw and remove the in-vehicle sensor.
INSTALLATION
Installation is in the reverse order of removal.
• Make sure that the aspirator hose is securely attached to the in-vehicle sensor when installing the instrument lower cover LH.
Control unit
Removal and Installation
FRONT AIR CONTROL
Removal
1. Remove cluster lid D. Refer to IP-12, "Removal and Installation".
2. Remove the two brackets (1) and remove the front air control ...
Sunload sensor
Removal and Installation
REMOVAL
1. Remove the front RH speaker grille (1). Refer to AV-73,
"Removal and Installation".
2. Disconnect the connector.
3. Release the sunload sensor ta ...
Other materials:
Stop lamp
Bulb Replacement
Removal
1. Remove rear combination lamp. Refer to EXL-257, "Removal and
Installation".
2. Turn bulb socket counterclockwise to unlock and remove from combination lamp
assembly.
3. Turn bulb counterclockwise to remove from bulb socket.
Installation
Installati ...
P1217 engine over temperature
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC UXXXX.
• If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis
for DTC P0607. Refer
to EC-361, "DTC Logic".
If the cooling fa ...
CVT position
Inspection and Adjustment
INSPECTION
1. Place selector lever in “P” position, and turn ignition switch ON (engine
stop).
2. Make sure that selector lever can be shifted to other than “P” position when
brake pedal is depressed.
Also make sure that selector lever can be shifted fro ...
