Nissan Altima 2007-2012 Service Manual: Inspection and adjustment

ECM RE-COMMUNICATING FUNCTION

 Description

Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1).

*1: New one means an ECM which has never been energized on-board.

(In this step, initialization procedure by CONSULT-III is not necessary) NOTE: • When registering new Key IDs or replacing the ECM that is not brand new, refer to CONSULT-III Operation Manual.

• If multiple keys are attached to the key holder, separate them before work.

• Distinguish keys with unregistered key ID from those with registered ID.

Special Repair Requirement

1.PERFORM ECM RE-COMMUNICATING FUNCTION

1. Install ECM.

2. Insert the registered keyfob (*2), turn ignition switch to “ON”.

*2: To perform this step, use the key that has been used before performing ECM replacement.

3. Maintain ignition switch in “ON” position for at least 5 seconds.

4. Turn ignition switch to “OFF”.

5. Start engine.

Can engine be started? YES >> Procedure is completed.

NO >> Initialize control unit. Refer to CONSULT-III Operation Manual.

    Pre-inspection for diagnostic
    Basic Inspection The engine start function, door lock function, power distribution system and NATS-IVIS/NMS in the Remote Keyless Entry system are closely related to each other regarding control. ...

    Other materials:

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...

    Horn
    Description Horn (high/low) is located inside of front bumper and operates when theft warning system is in alarm phase. Component Function Check 1.CHECK FUNCTION 1. Select HORN in “ACTIVE TEST” mode with CONSULT-III. 2. Check the horn (high/low) operation. Is the operation normal? ...

    B2606 steering lock relay
    Description The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication. IPDM E/R turns the steering lock relay ON and transmits the release of the steering to BCM. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2606 is displayed with DTC U1000, first per ...