Nissan Altima 2007-2012 Service Manual: Intermittents incident

Inspection Procedure

INTERMITTENT TROUBLE

An intermittent incident may have occured in the past but is not being detected currently. This DTC will not be detected on SELF DIAG [CURRENT], but may be viewed on SELF DIAG [PAST] using CONSULT-III.

Trouble Diagnosis with CONSULT-III

DIAGNOSTIC PROCEDURE 4

Check SRS Repair History

1.CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR

Check repair history of the SRS.

Have any previous repairs been made to the SRS? YES >> Self-diagnostic result “SELF-DIAG [PAST]” (previously stored in the memory) might not be erased after repair. Proceed to "DIAGNOSTIC PROCEDURE 3". Refer to SRC-14, "Self-Diagnosis Function (Without CONSULT-III)".

NO >> Proceed to "DIAGNOSTIC PROCEDURE 2". Refer to SRC-12, "SRS Operation Check".

    Diagnosis and repair work flow
    Work Flow OVERALL SEQUENCE *1 SRC-12, "Trouble Diagnosis Introduction" Introduction" *2 SRC-12, "SRS Operation Check" *3 SRC-5, "Trouble Diagnosis with CONSULT-II ...

    Other materials:

    Power steering fluid
    Inspection FLUID LEVEL • Check fluid level with engine stopped. • Make sure that fluid level is between MIN and MAX. • Fluid levels at HOT (A) and COLD (B) are different. Do not confuse them. CAUTION: • The fluid level should not exceed the MAX line. Excessive fluid will caus ...

    Common ITEM
    Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub system selecti ...

    Basic inspection
    DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2 2. CHECK DTC 1. Check DT ...