Nissan Altima 2007-2012 Service Manual: IPDM-E branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of IPDM E/R.

2. Check the resistance between the IPDM E/R harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the IPDM E/R branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the IPDM E/R. Refer to PCS-23, "Diagnosis Procedure" .

Is the inspection result normal? YES (Present error)>>Replace the IPDM E/R. Refer to PCS-48, "Removal and Installation".

YES (Past error)>>Error was detected in the IPDM E/R branch line.

NO >> Repair the power supply and the ground circuit.

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...

    Other materials:

    Diagnosis system (TCM)
    CONSULT-III Function (TRANSMISSION) CONSULT-III can display each diagnostic item using the diagnostic test modes shown below. FUNCTION WORK SUPPORT MODE Display Item List Engine Brake Adjustment CAUTION: Mode of “+1”“0”“−1”“−2”“OFF” can be selected by ...

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less. • Turn the ignition ...

    Camera image signal circuit (rear view camera to camera control unit)(coupe)
    Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control unit connector and rear v ...