Nissan Altima (L32) 2007-2012 Service Manual: Key slot
Diagnosis Procedure
1.CHECK KEY SLOT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect key slot connector.
3. Check voltage between slot connector and ground.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace key slot power supply circuit.
2.CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot connector and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace key slot ground circuit.
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
BCM
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fus ...
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
1.CHECK FUNCTION
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspectio ...
Other materials: Radio
Place the ignition switch in the ACC or ON
position and press the PUSHbutton
to turn the radio on. If you listen to the radio
with the engine not running, the ignition
switch should be placed in the ACC
position.
Radio reception is affected by station signal
strength, distance from radio transmitte ...
MOD system operation
The MOD system will turn on automatically
under the following conditions:
When the shift lever is in the R (Reverse)
position.
When the CAMERA button is pressed to
activate the camera view on the display.
When vehicle speed decreases below approximately
6 mph (10 km/h) and the
camera screen ...
Wiper and washer switch
Switch operation
WARNING
In freezing temperatures the washer
solution may freeze on the windshield
and obscure your vision which may
lead to an accident. Warm the windshield
with the defroster before you
wash the windshield.
CAUTION
Do not operate the washer continuously
for more than 30 seconds ...
POWER supply and ground circuit
Key slot illumination