Nissan Altima 2007-2012 Service Manual: Key slot

Diagnosis Procedure

1.CHECK KEY SLOT POWER SUPPLY CIRCUI

1. Turn ignition switch OFF.

2. Disconnect key slot connector.

3. Check voltage between slot connector and ground.

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace key slot power supply circuit.

2.CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace key slot ground circuit.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    IPDM E/R (Intelligent power distribution module engine room)
     Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible ...

    Key slot illumination
    Description Blinks when keyfob insertion is required. Component Function Check 1.CHECK FUNCTION Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode. Is the inspection resul ...

    Other materials:

    Warning chime system
    System Diagram System Description COMBINATION METER • The buzzer (1) for warning chime system is installed in the combination meter. • The buzzer sounds when the combination meter receives a buzzer output signal from each unit. BCM BCM receives signals from various units and transm ...

    Front wiper drive assembly
    Removal and Installation REMOVAL 1. Operate front wiper motor, and stop at the auto stop position. 2. Remove wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation". 3. Remove the cowl top cover. For Sedan Refer to EXT-39, "Removal and Installation". ...

    Starting system
    Wiring Diagram - Coupe Wiring Diagram - Sedan ...