Nissan Altima 2007-2012 Service Manual: Key slot

Removal and Installation

REMOVAL

1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation".

2. Disconnect key slot connector.

3. Remove the key slot screw (A), and then remove key slot (1) from instrument lower panel LH (2).

INSTALLATION

Installation is in the reverse order of removal.

    On-vehicle repair
    ...

    Push button ignition switch
    Removal and Installation REMOVAL 1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation". 2. Release the pawls (A) and remove the push-button ignition switch ...

    Other materials:

    P0452 Evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously condu ...

    Front fog lamp
    System Diagram System Description • BCM (Body Control Module) controls front fog lamp operation. • IPDM E/R (Intelligent Power Distribution Module Engine Room) operates front fog lamp according to CAN communication signals from BCM. • Combination meter operates front fog lamp indi ...

    The parking brake release warning continues displaying, or does not display
    Description • The parking brake warning is displayed while driving the vehicle even though the parking brake is released. • The parking brake warning is not displayed even though driving the vehicle with the parking brake applied. Diagnosis Procedure 1.CHECK PARKING BRAKE WARNING LAM ...