Nissan Altima 2007-2012 Service Manual: Key slot illumination
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspection result normal? YES >> Key slot function is OK.
NO >> Refer to SEC-114, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL
Check voltage between key slot connector and ground.
Is the
Is the inspection result normal? YES >> GO TO 6
NO >> GO TO 2
2.CHECK KEY SLOT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect key slot connector.
3. Check voltage between slot connector and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace key slot power supply circuit.
3.CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot connector and ground.
Is the inspection result normal? YES >> GO TO 4
NO >> Repair or replace key slot ground circuit.
4.CHECK KEY SLOT CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM and key slot connector.
3. Check continuity between BCM connector and key slot connector.
4. Check continuity between BCM connector and ground.
Is the inspection result normal? YES >> GO TO 5
NO >> Repair or replace harness between BCM and key slot.
5.CHECK KEY SLOT
Refer to DLK-83, "Component Inspection".
Is the inspection result normal? YES >> GO TO 6
NO >> Replace key slot. Refer to SEC-207, "Removal and Installation".
6.CHECK INTERMITTENT IN
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Key slot
Diagnosis Procedure 1.CHECK KEY SLOT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect key slot connector. 3. Check voltage between slot connector and ground. Is the inspect ...Key cylinder switch
Description For vehicles equipped with LH and RH anti-pinch system, the main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the ...Other materials:
Air breather hose
Exploded View
1. Air breather hose
2. Clip
3. Bracket
4. Air breather tube
5. CVT assembly
A. Paint mark
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Install air breather hose with paint mark facing upward.
• Insert air breather hose a m ...
Inspection and adjustment
Description & Conditions
DESCRIPTION
The purpose of the operational check is to confirm that the system operates
properly.
CONDITIONS:
• Engine running and at normal operation temperature.
Operational Check
STEP 1: Check Blower
1. Turn blower control dial clockwise, blower should oper ...
Front tweeter (coupe)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the front tweeters using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspec ...