Nissan Altima 2007-2012 Service Manual: Key slot illumination

Description

Blinks when Intelligent Key insertion is required.

Component Function Check

1.CHECK FUNCTION

Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.

Is the inspection result normal? YES >> Key slot function is OK.

NO >> Refer to SEC-313, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL

Check voltage between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 6

NO >> GO TO 2

2.CHECK KEY SLOT POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect key slot connector.

3. Check voltage between slot connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace key slot power supply circuit.

3.CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace key slot ground circuit.

4.CHECK KEY SLOT CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM and key slot connector.

3. Check continuity between BCM connector and key slot connector.

4. Check continuity between BCM connector and ground.

Is the inspection result normal? YES >> GO TO 5

NO >> Repair or replace harness between BCM and key slot.

5.CHECK KEY SLOT

Refer to SEC-313, "Description".

Is the inspection result normal? YES >> GO TO 6

NO >> Replace key slot. Refer to SEC-409, "Removal and Installation".

6.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    Key slot
    Diagnosis Procedure 1.CHECK KEY SLOT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect key slot connector. 3. Check voltage between slot connector and ground. Is the inspec ...

    Key cylinder switch
    Description For vehicles equipped with LH and RH anti-pinch system, the main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the ...

    Other materials:

    Rear window and outside mirror (if so equipped) defroster switch
    Type A To defrost the rear window glass and outside mirrors (if so equipped), start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defroster automat ...

    On-vehicle repair
    GENERATOR Removal and Installation QR25DE 1.-2. Tightening order 3. Generator 4. B terminal nut 5. Generator bracket bolts 6. Generator bracket Removal 1. Disconnect the battery negative terminal. Refer to PG-68, "Removal and Installation" (Coupe models) or PG-139, "Re ...

    POWER STEERING OIL PUMP
    Inspection RELIEF OIL PRESSURE CAUTION: Make sure that belt tension is normal before starting the following procedure. 1. Connect the Tool between oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to ST-8, "Inspectio ...