Nissan Altima 2007-2012 Service Manual: Key slot illumination

Description

Blinks when keyfob insertion is required.

Component Function Check

1.CHECK FUNCTION

Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.

Is the inspection result normal? YES >> Key slot function is OK.

NO >> Refer to SEC-505, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL

Check voltage between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 6

NO >> GO TO 2

2.CHECK KEY SLOT POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect key slot connector.

3. Check voltage between slot connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace key slot power supply circuit.

3.CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace key slot ground circuit.

4.CHECK KEY SLOT CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM and key slot connector.

3. Check continuity between BCM connector and key slot connector.

4. Check continuity between BCM connector and ground.

Is the inspection result normal? YES >> GO TO 5 NO >> Repair or replace harness between BCM and key slot.

5.CHECK KEY SLOT

Refer to SEC-505, "Description".

Is the inspection result normal? YES >> GO TO 6

NO >> Replace key slot. Refer to SEC-596, "Removal and Installation".

6.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    Key slot
    Diagnosis Procedure 1.CHECK KEY SLOT POWER SUPPLY CIRCUI 1. Turn ignition switch OFF. 2. Disconnect key slot connector. 3. Check voltage between slot connector and ground. Is the inspecti ...

    Key cylinder switch
    Description For vehicles equipped with LH and RH anti-pinch system, the main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the ...

    Other materials:

    Blower unit
    Removal and Installation COMPONENTS 1. Heater and cooling unit 2. Blower unit Front REMOVAL 1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and Installation". 2. Disconnect the blower motor connector. 3. Remove the screws from the blower unit, the ...

    USB interface (models without Navigation System) (if so equipped)
    Connecting a device to the USB input jack WARNING Do not connect/disconnect or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury. CAUTION ● Do not force the USB device int ...

    Operating range
    The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 . When the Intelligent Key battery is discharged or strong radio waves are present near the operating location, the Intelligent Key system’s operating ...