Nissan Altima (L32) 2007-2012 Service Manual: L Terminal circuit
Description
The terminal “2” (L) circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning lamp illuminates with the engine running, a malfunction is indicated.
Diagnosis Procedure
1.CHECK CHARGE WARNING LAMP CIRCUIT CONNECTION
Check to see if generator connector F7 terminal 2 is clean and tight.
Is the connection secure? YES >> GO TO 2
NO >> Repair the connection. Confirm repair by performing complete Starting/Charging system test.
Refer to Technical Service Bulletin.
2.CHECK CHARGE WARNING LAMP CIRCUIT
1. Disconnect generator connector F7.
2. Apply ground to generator harness connector F7 terminal 2 with the ignition switch in the ON position.
Does it illuminate? YES >> Check generator function. Refer to CHG-2, "Work Flow".
NO >> GO TO 3
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Turn ignition switch OFF.
2. Disconnect the generator connector F7.
3. Disconnect the combination meter connector M24.
4. Check continuity between generator harness connector F7 (A) terminal 2 and combination meter harness connector M24 (B) terminal 25.
Is continuity present? YES >> Replace the combination meter. Refer to MWI-176, "Removal and Installation".
NO >> Repair the harness or connector.
B Terminal circuit
Description The terminal “1” (B) circuit supplies power to charge the battery and operate the vehicles electrical system. Diagnosis Procedure 1.CHECK TERMINAL “1” CONNECTION 1. Turn ign ...S Terminal circuit
Description The output voltage of the generator is controlled by the IC regulator at terminal “3” (S) detecting the input voltage. Terminal “3” circuit detects the battery voltage to adj ...Other materials:
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
Turn signal and hazard warning
lamps
System Diagram
System Description
• BCM (Body Control Module) controls turn signal lamp (RH and LH) and hazard
warning lamp operation.
• Combination meter operates turn (RH and LH) indicator according to CAN
communication signals from
BCM.
Component Parts Location
1. BCM M16, M ...
Cleaning
If your windshield is not clear after using the
windshield washer or if a wiper blade chatters
when running, wax or other material may be on
the blade or windshield.
Clean the outside of the windshield with a washer
fluid or a mild detergent. Your windshield is clean
if beads do not form whe ...