Nissan Altima 2007-2012 Service Manual: Lan system can system (type 10)
COMPONENT DIAGNOSIS
- Main line between DLC and ABS circuit
- ECM branch line circuit
- A-BAG branch line circuit
- AV branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...Main line between DLC and ABS circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...Other materials:
P0335 CKP sensor (POS)
Description
The crankshaft position sensor (POS) is located on the oil pan facing
the gear teeth (cogs) of the signal plate. It detects the fluctuation of
the engine revolution.
The sensor consists of a permanent magnet and Hall IC.
When the engine is running, the high and low parts of the ...
Fuel pressure
Inspection
FUEL PRESSURE RELEASE
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III.
3. Start engine.
4. After engine stalls, crank it two or three times to release all fuel
pressure.
5. Turn ignition switch OFF.
1. Re ...
Electric ignition system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*1: This signal is sent to the ECM via the CAN communication line.
*2: ECM determines the start signal status by the signals of engine speed and
battery voltage.
SYSTEM DESCRIPTION
Ignition order: 1 - 2 - 3 - 4 - 5 - 6
The ig ...