Nissan Altima (L32) 2007-2012 Service Manual: Lan system can system (type 3)
COMPONENT DIAGNOSIS
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-BAG branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- ABS branch line circuit
- TCM branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
The fuel gauge pointer does not move
Description
Fuel gauge needle will not move from a certain position.
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Using “FUEL METER” of “DATA MONITOR”, compare the monitor value with the fuel
gauge reading on
the combi ...
Rear and rear-wide view monitor with moving object detection (MOD) (if so
equipped)
When the shift lever is shifted into the R (Reverse)
position, the monitor display shows view to
the rear of the vehicle.
The system is designed as an aid to the driver in
detecting large stationary objects to help avoid
damaging the vehicle. The system will not detect
small objects below th ...
Front wiper ARMS
Removal and Installation
REMOVAL
1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch
OFF (auto stop).
2. Open hood, remove arm caps, and remove wiper arm nuts.
3. Raise wiper arm, and remove wiper arm from the vehicle.
INSTALLATION
1. Clean up the pivot area as sho ...
