Nissan Altima 2007-2012 Service Manual: Lan system can system (type 4)

COMPONENT DIAGNOSIS

Can communication circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...

Main line between dlc and abs circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

Other materials:

B2605 PNP switch
Description BCM confirms the shift position with the following 4 signals. • CVT selector lever • P/N position switch • P position signal from IPDM E/R (CAN) • P position signal from TCM (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2605 is displayed with DTC U1000, first ...

Front door glass
Components 1. Door 2. Inside seal 3. Door glass 4. Regulator assembly 5. Door module assembly 6. Window motor 7. Cover Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation". 2. Remove the bolt hole covers. 3. R ...

Can communication system
System Description • CAN communication is a multiplex communication system. This enables the system to transmit and receive large quantities of data at high speed by connecting control units with two communication lines (CAN-H and CAN-L). • Control units on the CAN network transmit si ...