Nissan Altima 2007-2012 Service Manual: Lan system can system (type 5)
COMPONENT DIAGNOSIS
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-BAG branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
TPMS
System Diagram
System Description
BODY CONTROL MODULE (BCM)
The BCM is shown with the instrument panel LH removed. The BCM
reads the air pressure signal received by the tire pressure receiver,
and controls the low tire pressure warning lamp as shown below. It
also has a self-diagnosis funct ...
Body sealing
Description
The following figure shows the areas which are sealed at the factory. Sealant
which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to
apply an excess amount of
sealant and not to allow other unaffected parts to come into cont ...
Oil filter
Removal and Installation
REMOVAL
1. Remove the oil filter using Tool.
Tool number : KV10115801 (J-38956)
WARNING:
• Be careful not to get burned, the engine and engine oil
may be hot.
CAUTION:
• When removing, prepare a shop cloth to absorb any oil
leakage or spillage.
• Do not all ...