Nissan Altima (L32) 2007-2012 Service Manual: Low tire pressure warning lamp
blinks
Low Tire Pressure Warning Lamp Flashes When
Ignition Switch Is Turned On
NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A
• This mode shows transmitter status is OFF-mode.
Carry out transmitter wake up operation. Refer to WT-5, "Transmitter
Wake Up Operation".
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the Inspection result normal?
YES >> GO TO 2
NO >> Repair or replace damaged parts.
2.CHECK TIRE PRESSURE WARNING CHECK CONNECTOR CIRCUIT
Check continuity between BCM harness connector M18 terminal 57 and ground.
Continuity should not exist.
Is the Inspection result normal?
YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Repair circuit for short to ground.
Low Tire Pressure Warning Lamp Stays On When
Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Ch ...
Hazard Warning Lamps Flash When Ignition
Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM GROUND CIRCUIT
Check BCM ground circuit. Refer to BCS-42, "Diagnosis Procedure".
Is the i ...
Other materials: Checking engine oil level
2.0L 4 cylinder (KR20DDET engine
model)
1. Park the vehicle on a level surface and
apply the parking brake.
2. Start the engine and let it idle until it
reaches operating temperature.
3. Turn off the engine. Wait more than 10
minutes for the oil to drain back into
the oil pan.
4. Remove the dips ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
Manual shift mode (if so
equipped)
When the shift lever is in the D (Drive) position
and the drive sport mode switch is
pushed, the transmission is ready for the
manual shift mode. Shift ranges can be
selected manually by pulling the right-side
or left-side paddle shifter.
When shifting up, pull the right side paddle
shifter (+) B. ...