Nissan Altima (L32) 2007-2012 Service Manual: Low tire pressure warning lamp does not turn on

Nissan Altima (L32) 2007-2012 Service Manual / Road wheels & tires / Symptom diagnosis / Low tire pressure warning lamp does not turn on
11

Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is Turned On

DIAGNOSTIC PROCEDURE

1.SELF-DIAGNOSTIC RESULT CHECK

Using CONSULT-III, check display contents of BCM in SELF-DIAGNOSIS.

Is "CAN COMM CIRCUIT" displayed in the self-diagnosis display items? YES >> Malfunction in CAN communication system. Refer to LAN-25, "CAN System Specification Chart".

NO >> GO TO 2

2.CHECK COMBINATION METER

Check combination meter operation. Refer to MWI-38, "CONSULT-III Function (METER/M&A)".

Is the inspection result normal? YES >> GO TO 3 NO >> Replace combination meter. Refer to IP-12, "Removal and Installation".

3.CHECK LOW TIRE PRESSURE WARNING LAMP

Disconnect BCM harness connector.

Does the low tire pressure warning lamp activate? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Check combination meter operation.

    TPMS
    Symptom Table ...

    Low tire pressure warning lamp stays on
    Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.CHECK BCM CONNECTORS 1. Turn ignition switch OFF. 2. Disconnect BCM harness connectors. 3. Ch ...

    Other materials:

    Avoiding collision and rollover
    WARNING Failure to operate this vehicle in a safe and prudent manner may result in loss of control or an accident. Be alert and drive defensively at all times. Obey all traffic regulations. Avoid excessive speed, high speed cornering, or sudden steering maneuvers, because these driving practi ...

    P0117, P0118 ECT sensor
    Description The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in ...

    Line pressure test
    Inspection and Judgment INSPECTION Line Pressure Test Port (A) Line Pressure Test Procedure 1. Inspect the amount of engine oil and replenish if necessary. 2. Drive the car for about 10 minutes to warm it up so that the CVT fluid reaches in the range of 50 to 80°C (122 to 176°F), then ...