Nissan Altima (L32) 2007-2012 Service Manual: Low tire pressure warning lamp
stays on
Low Tire Pressure Warning Lamp Stays On When
Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace damaged parts.
2.CHECK BCM POWER SUPPLY AND GROUND CIRCUITS
Check BCM power supply and ground circuits. Refer to BCS-42, "Diagnosis
Procedure".
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Repair BCM circuits.
Low Tire Pressure Warning Lamp Does Not Come
On When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.SELF-DIAGNOSTIC RESULT CHECK
Using CONSULT-III, check display contents of BCM in SELF-DIAGN ...
Low Tire Pressure Warning Lamp Flashes When
Ignition Switch Is Turned On
NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A
• This mode shows transmitt ...
Other materials: Intelligent Driver Alertness system
operation
For vehicles with the 7 inch (18 cm)
display
For vehicles with the 5 inch (13 cm)
display
If the system detects driver fatigue or that
driver attention is decreasing, the message
"Take a break?" appears in the vehicle
information display and a chime sounds
when the vehicle is driven at speeds abov ...
RearView Monitor system operation
With the ignition switch in the ON position,
move the shift lever to the R (Reverse) position
to operate the RearView Monitor.
How to read the displayed lines
Guiding lines which indicate the vehicle
width and distances to objects with reference
to the vehicle body line A are displayed
on the monit ...
iPod player operation
Type-A.
Connecting iPod
WARNING
Do not connect, disconnect, or operate
the USB device while driving. Doing so
can be a distraction. If distracted you
could lose control of your vehicle and
cause an accident or serious injury.
CAUTION
Do not force the USB device into the
USB port. Inserting th ...