Nissan Altima (L32) 2007-2012 Service Manual ≻ Meter, warning lamp & indicator ≻ Function diagnosis ≻ Meter system

Nissan Altima (L32) 2007-2012 Service Manual: Meter system

System Diagram

System Description

COMBINATION METER

• Speedometer, odo/trip meter, tachometer, fuel gauge, engine coolant temperature gauge and information display are controlled by the unified meter control unit, which is built into the combination meter.

• Warning and indicator lamps are controlled by the unified meter control unit and by components connected directly to the combination meter.

• Digital meter is adopted for odo/trip meter.* *The record of the odometer is kept even if the battery cable is disconnected. The record of the trip meter is erased when the battery cable is disconnected.

• Odo/trip meter and information display segments can be checked in diagnosis mode.

• Meter/gauge can be checked in diagnosis mode.

Arrangement of Combination Meter

Component Parts Location

1. Combination meter M24

2. IPDM E/R E17, E18, E201, F10

3. ECM E10

4. TCM F16

5. BCM M17, M18, M19, M21 (view with instrument panel removed)

6. ABS actuator and electric unit (control unit) E26

7. Fuel level sensor unit and fuel pump (fuel level sensor) B42 (view with rear seat and inspection hole cover removed)

8. Ambient sensor E211 (view of front bumper fascia)

9. Oil pressure switch F41 (QR25DE) (view with engine removed)

10. Oil pressure switch F41 (VQ35DE) (view with engine removed)

11. Parking brake switch M73 (Sedan with M/T and Coupe) (view with center console removed)

12. Parking brake switch E35 (Sedan with CVT) (view with instrument lower cover LH removed)

Component Description

Function diagnosis

...

Speedometer

System Diagram System Description The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines. Component Parts Locat ...

Other materials:

Headlamp
Bulb Replacement HEADLAMP CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb. Do not touch bulb by hand while it is lit or right after being turned off, burning may result. Removal 1. Disconnect negative battery terminal. 2 ...

Automatic speed control device (ASCD)
System Diagram System Description INPUT/OUTPUT SIGNAL CHART *: This signal is sent to the ECM via the CAN communication line BASIC ASCD SYSTEM Refer to Owner's Manual for ASCD operating instructions. Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predetermine ...

B2191, P1615 Difference of key
Description Performs ID verification through BCM and keyfob when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ID of keyfob is used. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRM ...