Nissan Altima (L32) 2007-2012 Service Manual: Mixture ratio self-learning value
clear
Description
This describes show to erase the mixture ratio self-learning value. For the
actual procedure, follow the instructions
in “Diagnosis Procedure”.
Special Repair Requirement
1.START
1. Start engine and warm it up to normal operating temperature.
2. Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode with CONSULT-III.
3. Clear mixture ratio self-learning value by touching “CLEAR”.
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF.
3. Disconnect mass air flow sensor harness connector.
4. Restart engine and let it idle for at least 5 seconds.
5. Stop engine and reconnect mass air flow sensor harness connector.
6. Select Service $03 with GST. Check that DTC P0102 is detected.
7. Select Service $04 with GST to erase the DTC P0102.
>> END
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps engine idle speed within
the specific range. It must be performed under the following condi ...
Other materials: Manual anti-glare rearview mirror
(if so equipped)
Use the night position 1 to reduce glare
from the headlights of vehicles behind you
at night.
Use the day position 2 when driving in
daylight hours.
WARNING
Use the night position only when necessary,
because it reduces rear view
clarity.
Automatic anti-glare rearview mirror
(if so equipped)
The ...
I-FCW system limitations
Illustration A
Illustration B
WARNING
Listed below are the system limitations
for the I-FCW system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The I-FCW system cannot detect all
vehicles under all conditions.
The radar se ...
Turning the AEB with Pedestrian
Detection system ON/OFF
For vehicles with the 7 inch (18 cm) display
For vehicles with the 5 inch (13 cm) display
Perform the following steps to enable or
disable the AEB with Pedestrian Detection
system.
For vehicles with the 7 inch (18 cm) display.
1. Press the button until
"Settings" displays
in the vehicle informati ...