Nissan Altima (L33) 2013-2018 Owners Manual: Most common factors contributing to vehicle corrosion
● The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas.
● Damage to paint and other protective coatings caused by gravel and stone chips or minor traffic accidents.
Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for dry ...Other materials:
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1 ...
In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and
Installation".
2. Remove the in-vehicle sensor screw and remove the in-vehicle
sensor.
INSTALLATION
Installation is in the reverse order of removal.
• Make sure that the ...