Nissan Altima 2007-2012 Service Manual: Mudguard

Removal and Installation

REMOVAL

1. Remove the C205 push-pins located on the under body.

2. Remove the center mudguard screws and remove the center mudguard.

INSTALLATION

Installation is in the reverse order of removal.

    Fender protector
    Removal and Installation 1. Fender protector 2. Fender protector side cover A. J-clips B. Clips C. Center mudguard screw a. Sheet metal nut REMOVAL 1. Remove the engine under cover. Refer ...

    Side guard molding
    Removal and Installation 1. Double-faced adhesive tape Removal CAUTION: Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints. • Original side g ...

    Other materials:

    B210F PNP/clutch interlock switch
    Description IPDM E/R confirms the shift position with the following signals. • Park/neutral position (PNP) switch (CVT models) • Clutch interlock switch (M/T models) • Shift position signal from BCM (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210F is displayed with DTC U100 ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child Safety” and “Child Restraint” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restra ...

    Key slot illumination
    Description Blinks when Intelligent Key insertion is required. Component Function Check 1.CHECK FUNCTION Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode. Is the inspection result normal? YES >> Key slot function is OK. NO >> Refer to SEC-313, "Diagn ...