Nissan Altima (L32) 2007-2012 Service Manual: Multi av system (sedan)
System Diagram
System Description
The multi AV system consists of the following systems.
• Navigation system
• Audio system
• Rear view monitor
• Hands-free phone system
Refer to the following table for multi AV system descriptions.
VOICE RECOGNITION
The multi AV system uses voice recognition to control functions of the following systems:
• Navigation system
• Hands-free phone system
TOUCH PANEL
The multi AV system uses a touch panel display to control functions of the following systems: • Audio system
• Navigation system
• Hands-free phone system
Component Parts Location
1. Tweeter LH M51
2. Steering wheel audio control switches
3. CD changer M42
4. Tweeter RH M52
5. AV control unit M46, M47, M48, M81, M90, M91
6. Center speaker M151
7. Combination meter M24
8. Front door speaker
LH D3
RH D103
9. Rear subwoofer RH B124
10. Rear subwoofer LH B120
11. Rear door speaker
LH D202
RH D302
12. Antenna amp M502 (view with rear pillar finisher RH removed)
13. BOSE speaker amp. B121, B122
14. Microphone R7
15. Rear view camera control unit B31 (view with trunk side finisher LH removed)
16. Rear view camera B35
Component Description
Multi AV system (coupe)
System Diagram System Description The multi AV system consists of the following systems. • Navigation system • Audio system • Rear view monitor • Hands-free phone system Refer to ...Navigation system (coupe)
System Diagram System Description NOTE: Refer to NAVI System Owner's Manual for system operation. The navigation system periodically calculates the vehicle's current position according to the ...Other materials:
P0845 transmission fluid pressure
sensor B (pri pressure sensor)
Description
The transmission fluid pressure sensor B (primary pressure sensor) detects
primary pressure of CVT and
sends TCM the signal.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn
igniti ...
Interior light
1 The interior light can be turned ON regardless
of door position. The light will go off after
a period of time unless the ignition switch is
placed in the ON position when any door is
opened.
2 The interior lights can be set to operate
when the doors are opened. To turn off the
interi ...
P0500 VSS
Description
The vehicle speed signal is sent to the combination meter from the “ABS
actuator and electric unit (control
unit)” by CAN communication line. The combination meter then sends a signal to
the ECM by CAN communication
line.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P050 ...