Nissan Altima 2007-2012 Service Manual: Nissan vehicle immobilizer systemnats symptoms

Symptom Table

Security indicator does not turn ON or flash.

CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-10, "Work Flow"”. Determine malfunctioning condition before performing this diagnosis.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis.

• Check systems shown in the “Action” column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

• Intelligent Key is not inserted into key slot.

• Engine switch is not depressed.

    Vehicle security system symptoms
    Symptom Table *: Check the system is in the armed phase. ...

    Other materials:

    P2423 HC adsorption catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal. The phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal becomes small as the HC adsorption catalyst (under floor) is deteriorate ...

    P0138 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from t ...

    Steering switch (coupe)
    Description When one of the steering wheel audio control switches is pushed, the resistance in the steering switch circuit changes depending on which button is pushed. Diagnosis Procedure WITH BLUETOOTH 1.CHECK HARNESS 1. Turn ignition switch OFF. 2. Disconnect Bluetooth control unit con ...