Nissan Altima (L32) 2007-2012 Service Manual: Noise
Component Function Check
SYMPTOM: Noise
INSPECTION FLOW
*1 HAC-5, "Operational Check"
*2 EM-16, "Checking Drive Belts"
(QR25DE) or EM-121, "Checking
Drive Belts" (VQ35DE)
*3 HAC-87, "Performance Chart"
*4 HA-45, "Removal and Installation for
Expansion Valve"
*5 HA-35, "Removal and Installation for
Compressor - QR25DE Models" or
HA-36, "Removal and Installation for
Compressor - VQ35DE Models"
*6 HA-35, "Removal and Installation for
Compressor - QR25DE Models" or
HA-36, "Removal and Installation for
Compressor - VQ35DE Models"
*7 HA-21, "Maintenance of Oil Quantity
in Compressor"
*8 HA-42, "Removal and Installation for
Condenser"
Component Function Check
SYMPTOM: Insufficient heating
INSPECTION FLOW
SYMPTOM: Insufficient heating
1. CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE INCREASE
1. Press the AUTO swit ...
Diagnosis Procedure
SYMPTOM: Self-diagnosis cannot be performed.
1.CHECK SELF-DIAGNOSIS FUNCTION
1. Press ignition switch ON.
2. Set in self-diagnosis mode as follows. Within 10 seconds after s ...
Other materials: Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in serious
injury or death of a child or other
passengers in a sudden stop or collision:
The child restraint must be used
and installed properly. Always follow
all of ...
Rear-facing child restraint installation
using LATCH
For additional information, see all Warnings
and Cautions in the "Child safety"
and "Child restraints" before installing
a child restraint.
Do not use the lower anchors if the combined
weight of the child and the child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and the ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...