Nissan Altima 2007-2012 Service Manual: Noise

Component Function Check

SYMPTOM: Noise

INSPECTION FLOW

*1 HAC-102, "Operational Check"

*2 EM-16, "Checking Drive Belts" (QR25DE) or EM-121, "Checking Drive Belts" (VQ35DE)

*3 HAC-159, "Performance Chart"

*4 HA-45, "Removal and Installation for Expansion Valve"

*5 HA-35, "Removal and Installation for Compressor - QR25DE Models" or HA-36, "Removal and Installation for Compressor - VQ35DE Models"

*6 HA-35, "Removal and Installation for Compressor - QR25DE Models" or HA-36, "Removal and Installation for Compressor - VQ35DE Models"

*7 HA-21, "Maintenance of Oil Quantity in Compressor"

*8 HA-42, "Removal and Installation for Condenser"

    Insufficient heating
    Component Function Check SYMPTOM: Insufficient heating INSPECTION FLOW 1. CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE INCREASE 1. Turn temperature control dial clockwise to maximum ...

    Precaution
    Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alon ...

    Other materials:

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side). Is the in ...

    U0415 vehicle speed sig
    Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION 1. Erase the DTC. 2. Turn igniti ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit ...