Nissan Altima 2007-2012 Service Manual: None of the power windows can be operated using any switch

Diagnosis Procedure

1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit.

Refer to BCS-42, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY AND GROUND CIRCUIT

Check main power window and door lock/unlock switch power supply and ground circuit.

Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace the malfunctioning parts.

3. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH

Check main power window and door lock/unlock switch.

Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Symptom diagnosis
    ...

    Driver side power window alone does not operate
    Diagnosis Procedure 1. CHECK FRONT POWER WINDOW MOTOR LH Check front power window motor LH. Refer to PWC-114, "DRIVER SIDE : Component Function Check". Is the inspection result norma ...

    Other materials:

    P0850 PNP Switch
    Description When the shift lever position is P or N (CVT), Neutral position (M/T), park/neutral position (PNP) switch is ON. ECM detects the position because the continuity of the line (the ON signal) exists. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.INSPECTION START ...

    Vehicle security indicator
    Description • Vehicle security indicator is built in combination meter. • NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illumination of vehicle security indicator. Component Function Check 1.CHECK FUNCTION 1. Perform “ ...

    CD Changer
    Removal and Installation REMOVAL 1. Remove the Cluster D lower finisher. Refer to IP-12, "Removal and Installation". 2. Put selector lever in the drive "D" position (CVT models only). 3. Put shift lever in neutral (M/T models only). 4. Using a suitable tool remove t ...